HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Chapter 5 111
Modifying Your System
5.1 Securing and Backing Up the System for Tape Tasks
:PURGE HPINSTFL.INSTALL.SYS
12.Purge spool files.
:SPOOLF @;DELETE
13.Purge staging groups.
:PURGEGROUP UNL
:PURGEGROUP USL
:PURGEGROUP UXL
Verify each purge, type Y, at the prompt.
Do not purge the group install.sys or the file supacct.pub.sys; they are needed for
future patch and add-on processes.
14.If you are performing an Update task, go to Step 15.
If you are performing an Add-on task, go to Step 16.
Update Tasks
15.Purge specified files and groups.
a. Purge the PSIDNLD.DIAG.SYS file.
:PURGE PSIDNLD.DIAG.SYS
This file may have been purged already. This file is used for diagnostic purposes and
is overwritten by the new PSIDNLD.DIAG.SYS file. If you do not purge the existing
file, and the new file is larger, you will receive errors.
b. Purge each os
xnn and xpt nnnn group in the telesup account.
:REPORT OS?##.TELESUP
:PURGEGROUP OSxnn.TELESUP
:REPORT XPT####.TELESUP
:PURGEGROUP XPT@.TELESUP
where:
x — an alphabetic character
nn — the numeric release number (for example, OSA10.TELESUP and
0SB23.TELESUP).
These files may not exist.
c. Go to Step 16.
16.Rename the COMMAND.PUB.SYS file.
:RENAME COMMAND.PUB.SYS, command_name
where command_name is a temporary name you are assigning the file. This preserves
your UDC information for later use. Record the temporary name on your checklist.
• Securing and Backing Up the System for Tape Tasks completed. Go to the
next section on your checklist.