HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Chapter 4 97
Preparing Your System
4.11 Creating a Patch Tape or Staging Area
7. HP Patch/iX automatically returns you to the Main menu. The status indicates “Stage
Created,” “CSLT/STORE Tape Created,” or “Stage and Tape Created,” as appropriate for
your selection.
NOTE
Exiting HP Patch/iX is a
required
action for patch installation.
To exit HP Patch/iX:
1. From the HP Patch/iX Main menu, highlight the fifth option,
Exit HP Patch/iX
and
press
[Return]. Do not just press [F8].
The messages displays:
Patch Management completed successfully.
**EXITING HP PATCH/iX**
The MPE/iX prompt displays.
2. If you downloaded reactive patches from the HP SupportLine web site, respond to the
prompt to remove those files from your disk.
If you want to keep a copy of the downloaded patches, and you do not have a copy
elsewhere, select N.
If you respond Y, the PowerPatch and SUBSYS files are automatically cleaned up by HP
Patch/iX.
Do you want HP Patch/iX to automatically purge the reactive
patch files stored in PATCHXL.SYS? (y/n)
This completes the creation phase. You have created one or more of the following:
• Staging area for applying patches to your system.
• CSLT/ STORE tape for applying patches and SUBSYS products to your system, and for
archive purposes.
• STORE tape for applying patches to your system or for archive purposes.
— Creating a Patch Tape or Staging Area completed. Go to the next section on
your checklist.