HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

80 Chapter4
Preparing Your System
4.6 Creating the CSLT using HPINSTAL
Your keyword >>
NOTE Add-on product keyword can only be entered interactively.
9. Select to install all or a portion of the listed products:
Enter Y to select all products on the list.
Enter N to select a subset of the products, proceed to Step 10.
Do you want to install
all of the above products? (YES/NO)>>
If you accidentally type N, are viewing the list of products, and you do not wish to make
any changes to the list:
a. Type two slashes (//) or
[Return].
b. Confirm the products as you did in Step 7.
10.Optionally, create a subset list of products from the full list of products.
This is typically done to create a CSLT for use on a remote system, but can be done for
your local system as well.
CAUTION If you customize the list of products, and if you selected HPINSTAL option 1 or
2, it will create a CSLT with, and install, a subset of the master list of
entitled products.
If you update your local system with a subset of the master list of products, you cannot use
HPINSTAL, option 6 or 7, to add products to the local system.You must use HPINSTAL, option
1 or 2, and customize the subset list of products.
To create a subset list of products:
a. Enter N to the prompt in Step 9.
The N option puts HPINSTAL into customization mode. HPINSTALL displays the list of
products in the current PRODLIST.install.sys file.
b. Review this list and make changes as needed.
Edit the file to create the list of products that will be installed using the CSLT. Use
the CSLT created in this section to modify your remote system.
11.If you are performing a PowerPatch task, proceed to Step 12.
If you are performing an Add-on or Update task without a PowerPatch, proceed to
Step13.
PowerPatch Tasks
12.Restore patch information, qualify patches, and restore the patch files.
a. Mount the PowerPatch tape, as prompted.
b. Reply to the tape request.