HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Chapter 4 75
Preparing Your System
4.4 Initializing HP Stage/iX
4.4 Initializing HP Stage/iX
HP Stage/iX is part of the FOS. It is installed when the system software is updated to
version 5.5 or 6.0. You must be on version 5.5 or greater before you can use HP Stage/iX.
You cannot use HP Stage/iX to update from version 5.5 to 6.0.
NOTE
Not all patches are stageable. At the time of release 6.0, Stage/iX cannot
handle patches which involve System configuration files, MMSAVE.MPEXL.SYS,
nonsystem volume set files, and patches with files that contain jobs that are
streamed during patch installation. Patches will be identified as stageable or
not stageable during the installation process.
To initialize HP Stage/iX:
1. Determine if HP Stage/iX is already initialized.
:STAGEMAN STATUS
The following message displays if HP Stage/iX is not initialized:
The HP Stage/iX environment is not initialized.
2. If it is not initialized, type at the MPE/iX colon prompt:
:STAGEMAN INITIALIZE
The following message displays when HP Stage/iX initializes:
Successfully initialized the HP Stage/iX environment.
• Initializing HP Stage/iX completed. Proceed to the next section on your
checklist.