HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
74 Chapter4
Preparing Your System
4.3 Preparing to Run HPINSTAL
14.Set up the HPINSTAL environment by invoking the SETUP script.
:SETUP.INSTUTIL
Execute SETINIT command to cleanup any previous HPINSTAL accounting structure, if
prompted.
:SETINIT
A series of messages display. The process takes about five minutes. The final message
is:
setup is complete
15.If you are performing a PowerPatch task, proceed to Step 16.
If you are performing an Add-on or Update task without a PowerPatch, proceed to the
next section on your checklist.
PowerPatch Tasks
16.Mount the PowerPatch tape and restore the latest version of the HPINSTAL tool.
:FILE TAPE;DEV=TAPE
:RESTORE *TAPE;H@.INSTALL;SHOW;DEV=1
Two files, HPINSTAL and HICAT000, are added to the INSTALL.SYS group.
• Preparing to Run HPINSTAL completed. Proceed to the next section on
your checklist.