HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Appendix H 441
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
Globals file (/SYS/hpstage/stage_globals), which stores
critical information about the HP Stage/iX environment
and all known staging areas. The Globals file could not be
opened however because it was being held open
exclusively by another process at the time. The other
process was most likely STAGEMAN (or Patch/iX, which
runs STAGEMAN) running in another job or session, since
STAGEMAN always opens the Globals file for exclusive
access during the execution of a command.
Action Either terminate the additional STAGEMAN process, or
allow the command being executed by that process to
complete. The command can then be re-executed (or the
Patch/iX process restarted).
1171 Message Failed to open the HP Stage/iX Globals file. FSERR
=
value
(STAGEMAN 1171)
Cause STAGEMAN received a bad status from the file system
while attempting to open the HP Stage/iX Globals file
(/SYS/hpstage/stage_globals), which stores critical
information about the HP Stage/iX environment and all
known staging areas.
Action Determine the cause of the file open failure, correct the
problem, then re-execute the command (or restart the
Patch/iX process).
1172 Message The contents file for “
name
”
is temporarily in use by another process. Can't complete command.
(STAGEMAN 1172)
Cause The staging area's contents file
(/SYS/hpstage/stage_name/stage_contents), which
contains critical information about the staging area, could
not be opened because the file was being held open
exclusively by another process at the time. The other
process was most likely STAGEMAN (or Patch/iX, which
runs STAGEMAN) in another job or session, since
STAGEMAN always opens the relevant staging area
contents file for exclusive access during the execution of
each command.
Action Either terminate the additional STAGEMAN process, or
allow the command being executed by that process to
complete. The command can then be re-executed (or the
Patch/iX process restarted).
1173 Message Failed to open the contents file for “
name
”.
FSERR = value (STAGEMAN 1173)
Cause STAGEMAN received a bad status from the file system
while attempting to open the staging area's contents file
(the name of the contents file is