HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Appendix H 431
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
Cause A DUPLICATE operation failed, and to remove the
possibility of leaving behind a corrupt target (TO) staging
area, the target staging area was deleted. This error
normally prints after an initial DUPLICATE error is
printed, and is therefore issued for information purposes
only.
Action Reference the DUPLICATE error that immediately
preceded this one to help determine the cause of the
problem.
1086 Message Failed to delete bad staging area “
name ”.
(STAGEMAN 1086)
Cause The DUPLICATE operation failed, and to remove the
possibility of leaving behind a corrupt target (TO) staging
area, STAGEMAN attempted to delete the target staging
area. However, an error occurred during the delete
operation. The status of the target staging area is
unknown at this point.
Action Determine why the delete of the bad target staging area
failed. Contact your Hewlett-Packard Response Center for
assistance if necessary.
1087 Message Failed to rename staging area “
name1 ”
to “
name2 ”. Status: Subsys = value, Info = value (STAGEMAN 1087)
Cause The ;NAME= parameter of the CHANGE command was
selected, but STAGEMAN received an error while trying
to rename the staging area directory
(/SYS/hpstage/old_name --> /SYS/hpstage/new_name).
Action Contact your Hewlett-Packard Response Center for
assistance.
1088 Message The new staging area name is the same as the old
one. (STAGEMAN 1088)
Cause The ;NAME= parameter of the CHANGE command was
selected, but the new name supplied for the staging area
was the same as the current staging area name.
Action None.
1089 Message No parameters were given. No action taken.
(STAGEMAN 1089)
Cause A command was issued that expected one or more
parameters, but no parameters were provided, so
STAGEMAN did nothing.
Action None.
1090 Message The HP Stage/iX environment is not initialized.
(STAGEMAN 1090)