HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Chapter 2 41
Task Checklists
Checklist I. Modify Remote System
Checklist I. Modify Remote System
Use this task checklist if your source material was on CD-ROM and you are now using a
CSLT tape to:
• Update your remote system software version
• Update your remote system software version and applying PowerPatch patches
NOTE
• Before performing the activities in this checklist, you must have completed
the appropriate activities on the checklist H, “Update with CD-ROM.”
• For each remote system you are modifying, complete the activities in this
checklist.
• You cannot apply Reactive patches at the same time you are updating the
system. You must apply Reactive patches after you update the remote
system. To apply Reactive patches (after you update the system) refer to
Checklist A, “Manage Patches,” or Checklist B, “Manage Patches by
Staging Area.”
Print a copy of this checklist for each remote system that you are updating.
Read and perform the steps only in the following sections on your remote system:
Begin Preparation Tasks.
Does not require exclusive access to the system.
Log onto your remote system.
Chapter 3 , “Planning for Your Task.”
— 3.1 Verifying Required Materials
— 3.2 General Planning Tasks
— 3.4 Checking Tape Media
— 3.5 Checking Peripherals
— 3.6 Estimating Disk Space
Chapter 4 , “Preparing Your System.”
— 4.12 Reserving Disk Space for CD-ROM Tasks
Record contiguous disk space:
Record non-contiguous disk space:
Preparation Tasks completed.
Schedule downtime for exclusive access.
Begin Exclusive Access Tasks.