HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Appendix H 397
Error Messages and Warnings
Installer Error Messages (INSTERR)
205 Message Failed to copy filename to the local group.
(INSTERR #205)
Cause HPCICOMMAND intrinsic failed on the COPY command.
Action • Document any error message text that occurred prior to
the error.
• If the target file exists, purge it.
• Run HPINSTAL again.
• Contact the Response Center if further assistance is
required.
206 Message Failed to decrypt filename. (INSTERR #206)
Cause CUSTOM failed to decrypt an encrypted file.
Action • Ensure that HPINSTAL copied the specified file to the
local group.
• Purge the file.
• Run HPINSTAL again.
• Contact the Response Center if further assistance is
required.
207 Message Error trying to RUN SYSGEN.PUB.SYS. (INSTERR
#207)
Could not activate SYSGEN process, PIN = pin
number
Cause ACTIVATE failed on the newly created SYSGEN process.
Action Save all messages on the screen and check the messages in
the bottom of AUTOLOG. Call the Response Center for
further assistance.
208 Message Could not arm handler for switching the CD-ROM
volumes. (INSTERR #208) PEARM Error: info =
number, subsys = number
Cause The call to PEARM returned a nonzero status. Record the
listed status values before contacting the Response Center.
Action • Ensure HPCDXL.INSTALL.SYS exists and has no file
equations set on it.
• Ensure NL.PUB.SYS exists and has no file equations
set on it.
• Take appropriate corrective actions and restart
HPINSTAL.
209 Message Failed to initialize the CD-ROM volume names
through
the INITCIVR command file (INSTERR #209)