HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

380 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
to 100% on all system volumes except LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
— Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
143 Message Rename of filename1 to filename2 failed.
(INSTERR #143)
Cause The installer attempted to rename filename1 file to
filename2 and was unable to do so.
Action Check if a file named filename2 already exists. If so, purge
it, and restart.
144 Message Tape VUF and OS VUF do not match (INSTERR #144)
Cause The PowerPatch tape being used is not meant for the
current level of the Operating System.
Action • Use the correct PowerPatch tape and restart the
installer.
• Contact the Response Center if further assistance is
required.
145 Message The installer failed to build an ASAINTFL file.
(INSTERR #145)
Cause The installer was attempting to build a workfile:
ASAINTFL, and failed.
Action • Check and correct errors reported to terminal screen.
• Check for free disk space on system. There are two
methods for obtaining additional disk space:
• Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation assignments
to 100% on all system volumes except LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
— Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
146 Message The installer failed to build ASYSGNFL file.
(INSTERR #146)