HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

372 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
installation/update/patch process the CLEANXL was
issued.
• Check error message cause and action in the HP Link
Editor/iX Reference Manual.
• Take appropriate corrective measures and run the
installer again.
106 Message Error trying to RUN AUTOLED. (INSTERR #106)
Could not
create AUTOLED process. Createprocess error:
status
Cause The CREATEPROCESS intrinsic returned an error status
when attempting to execute LINKEDIT.PUB.SYS or
AUTOLED.INSTALL.SYS. If a special LINKEDITOR is
used it is named AUTOLED.INSTALL.SYS.
Action • Check the returned CREATEPROCESS error in the
MPE/iX Intrinsics Reference Manual.
• Print file AUTOLOG.INSTALL.SYS to check for
further errors.
• Check error message cause and action in the HP Link
Editor/iX Reference Manual.
• Ensure group for LINKEDIT has sufficient capabilities.
(need CAP=PH).
• If performing a PowerPatch operation:
— Verify that AUTOLED.INSTALL.SYS exists, if it is
the one used.
— Print file AUTOLOG.INSTALL.SYS to check for
further errors.
— Check error message cause and action in the HP
Link Editor/iX Reference Manual.
— Ensure the INSTALL.SYS group for AUTOLED has
sufficient capabilities. (need CAP=PH).
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
107 Message 107 Not used
108 Message Error trying to RUN SAINT.MPEXL.SYS. (INSTERR
#108)
Cause Could not create SAINT process. Createprocess error:
status