HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

370 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
• Restart the installer.
100 Message The patched program and data files were not
successfully stored.
To continue with the installation, refer to the
installation manual. (INSTERR #100)
Cause The JCW STOREJCW contained an error value after
execution of AUTOPSTR.INSTALL.SYS to store the patch
program and data files. AUTOPSTR is run with the INFO
string:
:STORE !TMPSTR02; STORTAPE;SHOW=OFFLINE;PROGRESS
Action • Ensure that a device with class LP is included in your
configuration.
• Check file equates, STORE command, etc.
• Reset STOREJCW to OK.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
101 Message The installer failed setting the file equation
for
INTLOG. (INSTERR #101)
Cause Setting the INTLOG file equation required by the installer
for the file INTLOG failed.
Action • FILE Command Table is possibly full. Do a LISTEQ
command to determine which USER file equations can
be RESET. RESET any USER file equations.
• Take appropriate corrective measures and run the
installer again. The installer will reissue any needed
file equations.
• Contact the Response Center if further assistance is
required.
102 Message The installer failed to purge AUTOLOG.INSTALL.
(INSTERR #102)
Cause The installer attempted to purge an old AUTOLOG file
and failed.
Action • Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is