HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Chapter 2 37
Task Checklists
Checklist G. Update with Tape
Checklist G. Update with Tape
Use this task checklist if your source material is on tape and you are using a CSLT tape
to:
• Update your system software version level
• Update your system software version level and apply PowerPatch patches
NOTE You cannot apply Reactive patches at the same time you are updating the
system. You must apply Reactive patches after you update the system. To
apply Reactive patches (after you update the system) refer to Checklist A,
“Manage Patches,” or Checklist B, “Manage Patches by Staging Area.”
Print a copy of this checklist for each system that you are updating.
Read and perform the steps only in the following sections:
Begin Preparation Tasks.
Does not require exclusive access to the system.
Chapter 3 , “Planning for Your Task.”
— 3.1 Verifying Required Materials
— 3.2 General Planning Tasks
— 3.4 Checking Tape Media
— 3.5 Checking Peripherals
— 3.6 Estimating Disk Space
Record contiguous disk space:
Record non-contiguous disk space:
Chapter 4 , “Preparing Your System.”
— 4.1 Reserving Disk Space for Tape Tasks
Preparation Tasks completed.
Schedule downtime for exclusive access.
Begin Exclusive Access Tasks.
Chapter 5 , “Modifying Your System.”
— 5.1 Securing and Backing Up the System for Tape Tasks
Record terminated logging processes:
Record system files with lockwords:
Record temporary filename for the COMMAND.PUB.SYS file:
— 5.2 Applying the SLT
— 5.4 Starting the System
.
— 5.7 Creating the CSLT Using AUTOINST— Select option 3 FOS, SUBSYS,