HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Appendix H 363
Error Messages and Warnings
Installer Error Messages (INSTERR)
required.
80 Message Build of the RELINKER patch file
RELINKFL.INSTALL.SYS
failed. (INSTERR #80)
Cause The installer was attempting to build the file
RELINKFL.INSTALL.SYS, to then write the link editor
relink procedure commands into the file.
Action • If old RELINKFL.INSTALL.SYS exists, purge it.
• Check for enough free disk space to build files. There
are two methods for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
81 Message Purge of the RELINKER patch file
NLLINK.INSTALL.SYS failed.
(INSTERR #81)
Cause The installer was attempting to purge the temporary work
NL, NLLINK.INSTALL used when relinking patched
procedures in the OS SOM.
Action • Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
82 Message Purge of the RELINKER patch file
INDIRREL.INSTALL.SYS
failed. (INSTERR #82)
Cause The installer was attempting to purge the file
INDIRREL.INSTALL.SYS. INDIRREL will be passed to
the link editor as an indirect file of procedure file names
and the commands used to relink the patched procedures.
Action • Examine file for accessors other than the installer.