HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

358 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
Cause The installer attempted to purge an old SYSINTR file
before beginning to patch NM intrinsics.
Action • Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
67 Message Purge of SPLINTR.INSTALL.SYS failed. (INSTERR
#67)
Cause The installer attempted to purge an old
SPLINTR.INSTALL file before beginning to patch CM
intrinsics.
Action • Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
68 Message Copy of SYSINTR.PUB.SYS to SYSINTR.INSTALL.SYS
failed.
(INSTERR #68)
Cause The installer was attempting to copy SYSINTR.PUB.SYS
to SYSINTR.INSTALL.SYS.
Action • Examine file SYSINTR.INSTALL.SYS for accessors
other than the installer.
• If SYSINTR.INSTALL.SYS is being accessed, free up
SYSINTR.INSTALL.SYS.
• Check for free disk space to copy file, and if needed free
up disk space. There are two methods for obtaining
additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
• Take appropriate corrective measures and run the
installer again.