HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

350 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
:SEGMENTER
-SL SL.INSTALL.SYS
-LISTSL
Press [[CTRL]] [[Y]] to stop listing all the SL
segments.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
41 Message AUTOGEN, AUTODEP VUF MISMATCH (INSTERR #41)
Cause AUTOGEN and AUTODEP from the PowerPatch tape
should have the same file VUF. This error can only be
caused if two different PowerPatch tapes are in use.
Action For AUTOINST:
• Restore A@,F@ from the correct PowerPatch.
• Take appropriate corrective measures and run the
installer to start installation again.
• Contact the Response Center if further assistance is
required.
For HPINSTAL:
• Restart HPINSTAL; it will restore the files from the
PowerPatch tape again. If the error occurs again,
contact the Response Center for assistance.
42 Message The installer failed to modify the JCW CIERROR.
(INSTERR #42)
Cause The installer could not modify the JCW CIERROR to
within a legal range.
Action • The inability to SETJCW CIERROR to a legal JCW
range is an indication of a corrupt session-level variable
table or another serious system problem.
• Document all messages prior to the error. Save the file
AUTOLOG.INSTALL.SYS. Report the problem to the
Response Center.
43 Message Error trying to RUN SOMPATCH.PUB.SYS. (INSTERR
#43)
Could not create SOMPATCH process. Create
process error: status
Cause The CREATEPROCESS intrinsic returned an error status
when attempting to execute SOMPATCH.PUB.SYS.
Action • Verify sompatch_filename is on your system.
• Print file AUTOLOG.INSTALL.SYS to ascertain