HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A

Appendix H 345
Error Messages and Warnings
Installer Error Messages (INSTERR)
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
26 Message Unable to recover installation file processing.
(INSTERR #26)
Cause The installer was stopped and restarted during IFILE
processing but could not find the last IFILE it was
working when stopped.
Action • A required installation file has been purged from the
system. Restore I???????.USL.SYS from the SUBSYS
tape:
:FILE T;DEV=TAPE
:RUN STORE.PUB.SYS;INFO=
RESTORE &
T;I???????.USL.SYS;SHOW
• Be sure to use the appropriate SUBSYS tape. Run the
installer again after the installation files have been
restored. Contact the Response Center if further
assistance is required.
27 Message The installer does not support streaming
external jobs from within installation files.
Job processing: ifilename (INSTERR #27)
Cause A JOB (SUPACCT or IFILE) includes a STREAM filename
command which is not allowed by the installer.
Action • If the USL, UXL, UNL groups were not purged prior to
starting the installation, purge them and restart the
installation procedures. Type:
:LISTF I???????.USL.SYS.
• If the file INDIRECT.USL.SYS exists, purge it.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
28 Message Internal error encountered at: location (INSTERR