HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Appendix H 343
Error Messages and Warnings
Installer Error Messages (INSTERR)
Restore the files from tape at the end of the
installation.
• Check if target file XL.INSTALL.SYS already exists.
Purge the XL.INSTALL.SYS file.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
20 Message The installer failed to copy NL.PUB.SYS.
(INSTERR #20)
Cause The installer failed to execute the command COPY
NL.PUB.SYS, NL to obtain a local copy of the NL.
Action • Ensure NL.PUB.SYS exists with the LISTF command.
• Check for free disk space to copy file. There are two
methods for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
• Check if target file NL.INSTALL.SYS already exists.
Purge the NL.INSTALL.SYS file.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
21 Message Cyclic job call encountered. Job processing:
ifilename (INSTERR #21)
Cause The installer has detected a loop of JOB streams.
Action If the USL, UXL, UNL groups were not purged prior to
starting the installation, purge them and restart the
installation procedures. Type:
:LISTF I???????.USL.SYS.
• If the file INDIRECT exists, purge it.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.