HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Appendix H 315
Error Messages and Warnings
Common Modification Process Errors
To recover from the above two messages, ensure that you have sufficient disk space before
proceeding with your modification task.
UPDATE Disk Space Message
The following message is generated by the UPDATE utility. UPDATE was not able to put all
the files on disk. UPDATE skips non-critical files and exists.
WARNING: UPDATE tried to find 60,000 sectors of contiguous disk
space on LDEV1 for its work, but it could only find
nnnnnnn
sectors. Before continuing, refer to the Installation Manual for
instructions on collecting enough contiguous space on LDEV1 for
the update. If you still have questions after attempting the
procedures outlined in the manual, call your HP support
representative for help.
You may override this warning and continue with the update, but
HEWLETT-PACKARD STRONGLY DISCOURAGES THIS COURSE OF ACTION.
DO NOT override this warning unless you have a full backup
available and the time to REINSTALL your system. If UPDATE runs
out of space on LDEV1, you risk having to REINSTALL.
Override this warning message [OVERRIDE/NO; default=NO]?
At the end of UPDATE, where the system normally boots, the system will stop. The
operator must boot the machine manually. Messages will stay on the console. The console
will have the following message on it.
ERROR.
This UPDATE did not restore all files from the tape.(UPDERR 1001)
There were # files not restored because of out of disk space. (1)
There were # files not restored for other than disk space
reasons. (2)
There is more information about the error conditions in previous
messages.
START the system, create more free disk space and run this UPDATE
again. (1)
Correct the problems and run this UPDATE again. (2)
Correct the problems, START the system, create more free disk
space and run this UPDATE again. (3)
END of LOAD (update).
INSTALL Group Capabilities
The INSTALL group is created with certain capabilities which AUTOINST needs to run. If
these capabilities are not present, the following message is displayed:
Program requires more capabilities than group is allowed.
(LDRERR505)
Native mode loader message 505 UNABLE TO LOAD PROGRAM TO BE RUN.
(CIERR 625)