HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Appendix G 307
HP Stage/iX Reference
HP Stage/iX Commands
Example
To show all defaults:
STAGEMAN$ SHOWDEFAULT
To show the defaults for all files in PUB.SYS type:
STAGEMAN$ SHOWD @.PUB.SYS
STAGEFILE (STAGEF,SF)
The STAGEFILE command is used to put a file into a staging area. The file can be anywhere
initially (referred to as its pre-stage location). You are required to specify the final target
filename for the file. This is the name that the file will ultimately have when the system is
booted from the staging area. In addition, you can optionally specify several pieces of
information about the file. This additional information will be used during boot-up when
processing the file.
The STAGEFILE command can be abbreviated as STAGEF or SF.
Expert Mode Command:
Syntax
STAGEFILE [STAGE=] stage_name [FROM=] from_file_name
[TO=] to_file_name
[;DISK={NONE}]
{CONTIG}
{LDEV1}
[;DISP={IGNORE}]
{REPLACE}
{ADD}
{DELETE}
[;ONERR={IGNORE}]
{WARN}
[;VAL={BASIC}]
{EXISTENCE}
{CHECKSUM}
[;VALINFO="validation_info"]
[;LIFTYPE={NONE} ]
{BOOT}
{IPL}
{DATA}
{AUTOF}
[;OWNER="owner_name"]
[;{MOVE}]