HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

302 AppendixG
HP Stage/iX Reference
HP Stage/iX Commands
[{ CONTINUE}] (optional) {NOCONTINUE}
If this parameter is omitted, the value of the CONTINUE option is unchanged. Otherwise the
value of the CONTINUE option is set to the value specified.
Example
To see what options are currently set:
STAGEMAN> OPTION
The following options are currently set: NOLIST, NOCONTINUE.
To set the list option to NOLIST and the continue option to CONTINUE:
STAGEMAN> OPTION NOLIST CONTINUE
RECOVER
The RECOVER command recovers a staging area that is not currently recognized by the HP
Stage/iX environment. This command is normally only necessary when recovering a
system with an INSTALL/UPDATE, where the HP Stage/iX environment has to be
re-initialized (INITIALIZE), and one or more staging areas have to be restored from tape.
In this case, each previously existing staging area that is restored from a backup needs to
be accepted into the HP Stage/iX environment with the RECOVER command. RECOVER
updates the system's HP Stage/iX Globals file with all appropriate information about the
staging area.
Syntax
RECOVER [STAGE=] stage_name
Parameters
[STAGE=]stage_name (required)
The name of the existing staging area to be recovered.
Example
To recover staging area “stage_1”:
STAGEMAN> RECOVER stage_1
REDO
The REDO command is identical in function to the MPE/iX redo command. It allows a
command in the command history stack to be edited and re-executed.
Syntax
REDO [COMMAND=] command_id
Parameters
command_id: (optional)
Specifies the command to re-execute. The command may be specified by its relative or