HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Appendix G 299
HP Stage/iX Reference
HP Stage/iX Commands
This parameter specifies whether or not the LIST command will display information about
specific files within a given staging area. The default value for this parameter is ;NOFILES.
If the ;FILES parameter is specified then the LIST command will display information for
each file in the staging area(s) about disk restrictions (LDEV1, contiguous, or none), file
disposition (add, replace, delete), and the file code, end-of-file, and limit values as they
would appear in a LISTF(ILE) output.
{;{NOPATCHES}] (optional)
{ PATCHES}
This parameter determines whether or not the LIST command will display information on
the specific patches in a given staging area. The default value for this parameter is
;NOPATCHES. If the ;PATCHES parameter is specified then the LIST command will display
the patch ID, date and time installed by HP Patch/iX, and a brief description for each patch
found in the staging area(s).
The ;PATCHES option will not be able to display any patch information if the file
PMSWINFO.PUB.SYS is not in the given staging area. This file is normally staged by the HP
Patch/iX product when the staging area is created. If this file does not exist in the staging
area, a message stating that no patch information is available will be displayed.
The patches displayed will be the sum of all patches applied by HP Patch/iX, which
includes any patches installed in the Base, as well as in the staging area.
Example
To see a list of all staging areas type:
STAGEMAN> list
STAGING AREA NAME MOD DATE V DESCRIPTION
----------------- -------- - ---------------------------------------
stage1 *^ 09/29/95 V PowerPatch 1 plus reactive patches
STAGE2 ^ 09/30/95 I PowerPatch 2
|
| --- (staging area is active and set for next boot)
To see a list of all staging areas that begin with the string “st”, and
information about all files and patches in each of those staging areas type:
STAGEMAN> l st@;files;patches
STAGING AREA NAME MOD DATE V DESCRIPTION
----------------- -------- - ---------------------------------------
stage1 *^ 09/29/95 V PowerPatch 1 plus reactive patches