HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
271
G HP Stage/iX Reference
This Appendix describes how to use HP Stage/iX in command mode and how to use
STAGEISL. Most HP Stage/iX functions can be performed through the command line
interface in addition to the HP Patch/iX interface.
Normally, to create, fill, and validate staging areas, use HP Patch/iX which performs these
functions automatically in addition to qualifying patches. Then to use and permanently
apply the files in a staging area, execute HP Stage/iX commands from the STAGEMAN
prompt.
This Appendix contains these sections:
• HP Stage/iX Concepts
• Using HP Stage/iX
• HP Stage/iX Commands