HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

Appendix D 223
Backdating Your System
Finishing Up
2. Set passwords for HP recommended users.
:ALTUSER username ;PASS= password
These users were created or modified to have OP (System Supervisor) and/or PM
(Privilege Mode) capabilities. Hewlett-Packard recommends that you set passwords for
these users.
3. Set passwords for MANAGER.SYS
:ALTACCT SYS;PASS= password
:ALTUSER MANAGER;PASS= password
4. Identify system files.
:SYSGEN
sysgen>SYSFILE
sysfile>SHOW
Record the list of files
sysfile>EXIT
sysgen>EXIT
5. Reapply or add lockwords to the system, as required.
If you removed any lockwords from the system earlier, reapply them now. Do not apply
lockwords to system files.
:RENAME filename,filename/lockword
6. Review account security.
Refer to Controlling System Activity Manual and the HP
Security Monitor/iX Managers Guide.
7. Reenter customized changes to CATALOG.PUB.SYS.
Enable UDCs
Refer to “Enabling UDCs” in Chapter 6 , “Finishing the Process,” for additional
information about these steps.
1. Purge the command file:
CLL HPOPTMGT HPSPOOL RJE SYSLOG NETWARE
CONV HPPL85 INDHPE SAMBA SYSMGR SOFTREP
HPLANMGR HPPL87 INTSETUP SNADS TELESUP
HPNCS HPPL89 ITF3000 SUPPORT WWW
Table D-3. Password Recommended Users
MANAGER.SYS FIELD. HPPL85 MGR.SNADS MGR.JAVA
MGR.HPOFFICE MGR.TELESUP MGR.SYSMGR
Table D-2. Password Recommended HP Accounts