HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Appendix D 217
Backdating Your System
Performing the Backdate
2. Modify or restore configuration files.
a. Type at the prompt.
:SYSGEN
sysgen>IO
io>LPATH
b. Record configuration and compare to the configuration listed by ODE.
c. Change the configuration to match the ODE listing.
d. Save changes.
io>HOLD
io>EXIT
sysgen>KEEP CONFIG
purge old configuration? YES
sysgen>EXIT
A warning message displays regarding nmconfig. Ignore it.
3. Shutdown the system.
CTRL-A
=SHUTDOWN
4. Reset the system.
As appropriate to your system, do either Step a or Step b:
a. For HP 3000 Series 991 or 995:
CTRL-B
CM>SP
SP>RS
Enter Y to HARD BOOT the computer system.
b. For all other systems:
CTRL-B
SP>RS
If the system does not respond, press the reset button, key switch, or on/off switch as
appropriate for your system.
Enter Y to confirm restarting the system.
5. Boot the system from the primary boot path.
a. Boot messages can vary, depending on the system model.
b. Enter Y to the Interact
with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
6. Start the system.
ISL>START NORECOVERY