HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Appendix D 211
Backdating Your System
Performing the Backdate
STORE/RESTORE VERSION A.
nn.nn
(C) HEWLETT-PACKARD CO.
b. Reply to the tape request.
c. Dismount the FOS tape when the restore complete message displays.
The files from the FOS tape were successfully restored.
AUTOINST creates the accounting structure. Progress messages display throughout
this 5 minute process. The ending message is:
The accounting structure has been successfully created.
9. Respond to SUBSYS prompt.
If you have a SUBSYS, enter Y at the prompt, and proceed to Step 10.
If you do not have a SUBSYS, enter N at the prompt, and proceed to Step 11.
Has a SUBSYS tape been included in your installation package
(y/n)?
10.Restore SUBSYS files, if you have purchased products to add-on to your system
software.
This step takes about 20–45 minutes.
a. Mount SUBSYS tape and reply to tape request (for SUBSYS and PowerPatch tape,
as applicable) when the following message displays.
Mount the SUBSYS tape and put the tape drive online.
The HP-Supported software files will be restored.
***** PLEASE STAND BY *****
The HP-Supported software files are being restored.
CREATE' OPTION DEFAULTING TO `CREATE=ACCOUNT,GROUP,CREATOR'
BASED ON YOUR CAPABILITIES (S/R 502)
STORE/RESTORE VERSION A.
nn.nn
(C) HEWLETT-PACKARD CO.
b. Reply to the tape request.
c. Dismount the SUBSYS tape when the restore complete message displays.
The SUBSYS tape has been successfully restored.
• AUTOINST automatically streams the installation jobs that complete the
installation of most products.
The message may indicate zero installation files. This only means that the
products you are installing do not require an installation file. AUTOINST
continues with the product installation.
• AUTOINST creates a copy of the system libraries and displays:
• AUTOINST processes the files.
• AUTOINST updates the temporary copies of the system libraries.
11.Create the CSLT.
Respond to tape request and mount a blank/scratch (write-enabled) tape.