HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

202 AppendixD
Backdating Your System
Performing the Backdate
:HELLO MANAGER.SYS,INSTALL;HIPRI
:LIMIT 1,1
:SPOOLER LP;OPENQ
:STREAMS streams_device
where streams_device is the device number. A common streams_device value is 10.
An LP device must be configured in SYSGEN. Already spooled and streamed messages
might display.
Restore FOS and SUBSYS
Refer to “Creating the CSLT Using AUTOINST” in Chapter 5 , “Modifying Your System,” for
additional information about these steps.
1. Run AUTOINST.
:RUN AUTOINST.Install.SYS
2. Select option 4 FOS, SUBSYS and reply to the tape request.
Please choose and enter the number corresponding to the software
you want to install.
1 PowerPatch Only
2 SUBSYS (Add-On) and PowerPatch
3 FOS, SUBSYS, and PowerPatch
4 FOS, SUBSYS, (Installation only)
5 SUBSYS only, (Add-on only)
6 Exit
Enter your choice 4
3. Reply to prompt for LDEV number.
Press Return to use the default device class TAPE or enter the LDEV number of the
tape device. The device you specify applies to all tape requests.
CAUTION Failure to specify an LDEV number will result in a program hang while
writing to tape. If this occurs, a tape request will keep reappearing and will
not take the specified LDEV number as input.
The file equation from the tape device, which is used to
restore files and create the CSLT, defaults to 'DEV=TAPE'.
If you prefer to designate a different device, enter its LDEV
number now (RETURN for default)>>
4. Restore FOS files.
This step takes about 20–45 minutes.
a. Mount FOS tape and reply to tape request when the following message displays.
Mount the FOS tape and put the tape drive online. The files from
the FOS tape will now be restored.
**** PLEASE STAND BY ****