HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Appendix A 175
Manually Installed Products
Configuring File Transfer Protocol (FTP)
Configuring File Transfer Protocol (FTP)
To configure FTP so it is enabled after the update or install of MPE/iX 6.0:
1. Remove any passwords from MANAGER.SYS.
2. Stream FTPCNFJ.ARPA.SYS.
:STREAM FTPCNFJ.ARPA.SYS.
This will add FTP entries to the appropriate Internet Super Daemon files.
For more information on the specifics of these entries, refer to the Installing and
Managing HP ARPA File Transfer Protocol Network Manager’s Guide, in the chapter
“Starting FTP”.
3. Reset any passwords on MANAGER.SYS that Step 1 removed.