HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Appendix A 173
Manually Installed Products
Configuring HP Predictive Support
Configuring HP Predictive Support
The directions in this section only describes how to update an existing version of HP
Predictive Support.
To configure HP Predictive Support for the first time, please contact your Hewlett-Packard
Customer Engineer who will do the initial configuration and provide the HP Predictive
Support User’s Guide and the HP Predictive Support User’s Guide Addendum.
To update HP Predictive Support:
After updating your system, you must start the HP Predictive Support run to ensure a
complete update.
1. Log on as MANAGER of the SYS account.
:HELLO MANAGER.SYS;HIPRI
2. Run HP Predictive Support’s user interface (PSCONFIG).
:RUN PSCONFIG.PRED;INFO= “RUN”
3. Review the Action Summary Report that may be generated by the run for any actions
you must take.
You may need to run PSCONFIG and enter coverage information for newly supported or
additional devices. This run of HP Predictive Support automatically includes data
transfer to the Response Center, as required.
For detailed information on configuring HP Predictive Support, see the HP Predictive
Support User’s Guide. For information on HP Predictive Support enhancements for
MPE/iX 5.0, see the HP Predictive Support User’s Guide Addendum .