HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

154 Chapter6
Finishing the Process
6.8 Restarting Selected System Functions
6.8 Restarting Selected System Functions
To restart selected system functions:
1. Log on.
:HELLO MANAGER.SYS;HIPRI
On local systems power cycle the DTCs. If you are using OpenView DTC Manager, the
DTCs do not need to be power cycled. On remote systems reset DTCs.
To power cycle all DTCs:
a. Turn DTC off.
b. Turn DTC on.
Power cycling each DTC enables the new download file and the DTC configurations to
be downloaded to the DTC(s).
To reset DTCs on remote systems:
a. Type:
:SYSDIAG
DUI>TERMDSM
b. For each DTC, type:
DUI>RESET DTC nn
where nn is the DTC number.
2. Purge groups.
:PURGEGROUP USL
:PURGEGROUP UXL
:PURGEGROUP UNL
3. Start data communications.
If you have NS 3000/iX configured, bring up the configured network interfaces. For
more information, refer to the HP 3000/iX Network Planning, and Configuration
Guide.
NOTE Use the same names for the network interfaces that were used in your
configuration.
• For example, if you have configured network interfaces with the names LOOP and
LAN1, enter:
:NETCONTROL START;NET=LOOP
:NETCONTROL START;NET=LAN1
:NSCONTROL START
• If you have configured only the router network interface with the name ROUTER1,
enter: