HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

152 Chapter6
Finishing the Process
6.7 Performing the Final Reboot
6.7 Performing the Final Reboot
To reboot and restart the system:
1. Shut down the system.
CTRL-A
=SHUTDOWN
2. Reset the system after the last shutdown message (SHUT6).
a. If you have an HP 3000 Series 991 or 995, connect to the service processor before you
can restart the system.
Type the following:
CTRL-B
CM>SP
CM>RS
Enter Y to HARD BOOT the computer system.
Do not respond to the question, Press any key within
10 seconds to cancel boot with this configuration. After 5 to 10 minutes of
system activity, the Processor Dependent Code (PDC) screen displays.
b. For all other systems.
Enter the following commands to reset the system:
CTRL-B
SP>RS
If the system does not respond to the CTRL-B entry within ten seconds, press the
reset button, key switch, or on/off switch as appropriate for your system. The system
will halt, and then restart automatically.
Enter Y to confirm restarting the system.
3. Boot the system from the primary boot path. Boot messages can vary, depending on the
system model.
• If you have AUTOBOOT enabled, the system boots from the primary boot path
automatically, if you do not override AUTOBOOT.
• If your system prompts to enter the boot path, enter the primary boot path.
• For Model 9x8LX, 9x8RX, or 9x9KS systems, type BO at the PDC screen to boot from
the primary boot path.
• If your system prompts, Boot from primary
boot path?, enter Y.
• Enter Y to the Interact with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
4. At the ISL prompt, enter: