HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

148 Chapter6
Finishing the Process
6.4 Setting Passwords, Lockwords, and UDCs
6.4 Setting Passwords, Lockwords, and UDCs
To set passwords, lockwords, and UDCs:
1. Review account security.
Refer to Manager’s Guide to MPE/iX Security and the HP Security Monitor/iX
Managers Guide.
2. Set passwords for HP recommended accounts, if these accounts do not have passwords,
see Table .
:ALTACCT acctname ;PASS= password
3. Set passwords for users that were created or modified to have OP (System Supervisor)
and/or PM (Privilege Mode) capabilities, see Table .
:ALTUSER username ;PASS= password
4. Confirm that passwords are set for SYS account and user MANAGER.SYS.
5. Identify system files.
:SYSGEN
sysgen>SYSFILE
sysfile>SHOW
Record the list of files.
sysfile>EXIT
sysgen>EXIT
6. Reapply or add lockwords to the system, as required. Refer to your list for the
previously lockworded files.
:RENAME filename,filename/lockword
7. Enable UDCs. Purge the COMMAND file created during the process and rename your
temporary COMMAND file.
:PURGE COMMAND.PUB.SYS
Table 6-1. Password Recommended HP Accounts
BIND HPOFFICE HPSKTS JAVA SYS
CLL HPOPTMGT HPSPOOL RJE SYSLOG
CONV HPPL85 INDHPE SAMBA SYSMGR
HPLANMGR HPPL87 INTSEUP SNADS TELESUP
HPNCS HPPL89 ITF3000 SUPPORT WWW
Table 6-2. Password Recommended Users
MANAGER.SYS FIELD. HPPL85 MGR.SNADS MGR.JAVA
MGR.HPOFFICE MGR.TELESUP MGR.SYSMGR