HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)

138 Chapter5
Modifying Your System
5.17 Rerunning HP Patch/iX
5.17 Rerunning HP Patch/iX
For Phase II of HP Patch/iX, you must log onto the system Console and have exclusive
access to your system.
To rerun HP Patch/iX and finish applying the CSLT or STORE tape:
1. Log onto the Console.
:HELLO MANAGER.SYS,INSTALL;HIPRI
2. Lower session and job limits.
:LIMIT 1,1
3. Warn, then log off users.
:WARN@ PLEASE LOG OFF! SYSTEM UPDATE ABOUT TO BEGIN
Use the SHOWJOB command to determine session and job numbers. Then, for each job
and session still executing (except yours), type:
:ABORTJOB #J nn
:ABORTJOB #S nnn
where:
J
nn the ID number for each job to be aborted.
S
nnn the ID number for each session to be aborted.
4. Ensure that the network is not running.
:NSCONTROL STOP
:NSCONTROL ABORT
:NETCONTROL STOP
5. Reset the outfence.
:OUTFENCE 14
6. Stop each automatically spooled network printer.
:SPOOLER print_device ;STOP;OPENQ
where print_device is the LDEV or class of the network printer.
7. Make sure the LP and STREAMS device are up.
:OPENQ LP
:SPOOLER LP;START
:STREAMS streams_device
A common streams_device value is 10. An LP device must be configured in SYSGEN.
8. Rerun HP Patch/iX.
:RUN PATCHIX.INSTALL.SYS
9. You must respond YES to resume the installation and complete the task at the prompt:
HP Patch/iX has found a recovery file that indicates phase I
completed successfully, are you ready to begin phase II of