HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
130 Chapter5
Modifying Your System
5.13 Applying the CSLT Modification
The system displays initialization and restore messages.
c. Go to Step 11.
Reinstall Tasks
10.Proceed with the re-installation.
CAUTION
DO NOT DO THIS UNLESS YOU ARE PERFORMING A REINSTALL. IT
DESTROYS ALL THE EXISTING SYSTEM AND USER FILES IN THE
MPEXL_SYSTEM_VOLUME_SET!
a. Type at the ISL prompt:
ISL>install
The system displays initialization and restore messages.
b. Go to Step 11.
11.Confirm the date and time.
If the date and time displayed are not correct, enter N, and enter the correct date and
time. If you do not respond within 15 seconds, the system continues.
The system displays an initialization message.
The system continues to restore the files from the CSLT. This process can take 10–25
minutes. During this process, the system displays initialization and restore messages.
If AUTOBOOT is ON, the system will boot from the AUTOBOOT file unless interrupted by you
within ten seconds. If AUTOBOOT is OFF
(as recommended), you do not have to watch for the reset prompt.
The system displays the following message regardless of whether or not AUTOBOOT is
enabled.
Restoring system file "C0040000.DIAG.SYS"
END of LOAD (update).
Auto boot in progress.
When the Update or Install process completes, the SPU resets.
12.Remove the CSLT tape.
• Applying the CSLT Modification completed. Go to the next section on your
checklist.