HP e3000 MPE/iX Release 6.0 System Software Maintenance Manual (30216-90272)
Table Of Contents
- Preface
- 1 Introduction
- 2 Task Checklists
- 3 Planning for Your Task
- 4 Preparing Your System
- 5 Modifying Your System
- 6 Finishing the Process
- A Manually Installed Products
- B Configuration Tables
- C Managing Disk Space
- D Backdating Your System
- E CD-ROM Resources
- F HP Patch/iX Reference
- G HP Stage/iX Reference
- H Error Messages and Warnings
- A
Chapter 5 111
Modifying Your System
5.5 Configuring the System
Press any key within 10 seconds to cancel boot with this configuration.
There are 5 to 10 minutes of system activity, then the Processor Dependent Code
(PDC) screen displays.
b. For all other systems, enter the following commands to reset the system:
CTRL-B
CM>RS
If the system does not respond to the CTRL-B entry within ten seconds, press the
reset button, key switch, or on/off switch as appropriate for your system. The system
will halt, and then restart automatically.
Enter Y to confirm restarting the system.
7. Boot the system from the primary boot path.
a. Boot messages can vary, depending on the system model.
• If you have AUTOBOOT enabled, and you do not override AUTOBOOT, the system
boots from the primary boot path automatically.
• If your system prompts to enter the boot path, enter the primary boot path.
• For Model 9x8LX, 9x8RX, or 9x9KS systems, type BO at the PDC screen to boot
from the primary boot path.
• If your system prompts, Boot from primary
boot path?, enter Y.
b. Enter Y to the Interact with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
8. Start the system.
ISL>START NORECOVERY
• Configuring the System completed. Go to the next section on your
checklist.