HP Driver for JDBC User's Manual

Chapter 3 27

Installation

Conﬁguring HP JDBC Server

The HP JDBC Server components behave the same on both the HP-UX

and MPE/iX platforms. Thus both the conﬁguration ﬁle and log ﬁle are

the same (except for ﬁlenames).

The following example shows the standard HP JDBC default server

conﬁguration ﬁle, servcfg. This is a text ﬁle that resides on the server

host in the same directory as the HP JDBC Server executable ﬁles and

can be used to alter some of the server’s behavior.

LOGFILE /opt/allbase/jdbc/logs/servlog

TIMEOUT 7200

#LOGGING ERROR

#LOGGING CONNECTION

#LOGGING INFO

#LOGGING WARNING

#LOGGING FATAL

#LOGGING IN

#LOGGING OUT

#LOGGING INHEX

#LOGGING OUTHEX

#LOGGING DEBUG

#LOGGING TIMESTAMP

LOGGING NONE

# If LOGGING NONE is not commented out, it must be the

# last line for it to have the desired effect.

The ﬁrst conﬁguration option LOGFILE refers to the path and ﬁlename

for the HP JDBC Server log ﬁle. On HP-UX this is normally set to

/opt/allbase/jdbc/logs/servlog. On MPE/iX this is normally set to

SERVLOG.JDBC.SYS.

The second conﬁguration option TIMEOUT speciﬁes the number of

seconds that the HP JDBC Server can remain idle before terminating.

The next set of lines are the LOGGING levels used to determine the type

of information to be logged to the server log ﬁle. The meanings of the

various logging levels are discussed in the Troubleshooting Section,

under “Server Logging” of the HP Driver for JDBC User’s Manual.