HP Data Entry and Forms Management System (VPLUS) Reference Manual (32209-90024)

Appendix B 533
VPLUS Error Messages
VPLUS Intrinsic Error Messages
**** Error writing
OUTPUT file (VM1901)
Self-explanatory. Correct the problem
that has caused the
write error and rerun
VMERGE. You may
need to consult with
your system
administrator to
determine the problem.
OUTPUT file opened
(VM1903)
Self-explanatory. None.
***** OUTPUT file type
is not VFAST (VM1904)
The file designated as OUTPUT
pre-exists but is not of type VFAST.
This is viewed as an
error since it is assumed
that the user has
unintentionally
designated the name of
a file being used for
other purposes.
Redesignate the
OUTPUT file (or purge
the old file if the name is
correct) and rerun
VMERGE.
OUTPUT file designated
as: fff ... f (VM1905)
Shows the full pathname of the
OUTPUT file
None
Error closing OUTPUT file
(VM1906
Self-explanatory. Correct the problem
that has caused the
error and rerun
VMERGE. You may
need to consult with
your system
administrator to
determine the problem
***** OUTPUT file
purged (VM1911)
Inconsistency or some other problem
has prevented the OUTPUT file from
being successfully generated. To avoid
confusion, the file is purged.
Correct the underlying
problem and rerun
VMERGE
***** OUTPUT file
pre-existed and could
not be purged (VM1912)
An attempt to purge the existing file
with the name designated for the
OUTPUT file failed.
Make sure that the
correct file name has
been designated. If so,
determine why it could
not be purged and
remove the impediment
Message Cause/Action Action