HP Data Entry and Forms Management System (VPLUS) Reference Manual (32209-90024)

522 AppendixB
VPLUS Error Messages
VPLUS Intrinsic Error Messages
VPLUS Intrinsic Error Messages
VOPENTERM and VCLOSETERM Messages
Error Message Cause/Action
001
Internal error: Terminal file
initialization failed. failed.
FCONTROL or FSETMODE intrinsic
002
Your terminal is not supported
by VPLUS.
VPLUS works on the HP terminals listed in
Appendix G.
003
VPLUS does not run on a series
I.
VPLUS does not run on an HP Series I
computer system.
004
The terminal status request
failed.
VOPENTERM’s request for terminal status
failed. Check that strapping is correct. May
also be data comm problem.
005
The terminal allocation failed.
Message used only with the 2640A terminal,
which is not supported by VPLUS. Reserved
words in the COMAREA are not initialized to
zeroes.
006
The terminal needs the H strap
in (closed).
Refer to AppendixG for instructionson how to
strap your terminal for VPLUS.
007
Internal error: HP2640 mode
could not be correctly set.
Possible block mode or data comm problem.
008
Internal error: HP2645 mode
could not be correctly set.
See error 007.
009
The terminal open failed.
(FSERR !)
FOPEN
intrinsic failed.
010
The terminal close failed.
(FSERR !)
FCLOSE
intrinsic failed.
011
Sorry, this device is not
supported by VPLUS.
Refer to Appendix G for a list of supported
terminals.
012
The HP2640B needs straps A, C,
H in (closed); D, F, G out.
You must strap this terminal (and the 2644A)
yourself; other terminals are strapped
automatically. (Refer to Appendix G.)
013
The HP2644A needs straps A, C,
H in (closed); D, G out.
You must strap this terminal (and the 2640B)
yourself; other terminals are strapped
automatically. (Refer to Appendix G.)
014
The HP2645A/41A/48A needs
straps A, C, H, J in (closed);
D, G out.
Note that these terminals should be
configured automatically by VPLUS.