HP Data Entry and Forms Management System (VPLUS) Reference Manual (32209-90024)

498 AppendixB
VPLUS Error Messages
FORMSPEC Error Messages
723
Selection must be one of the
characters listed below.
Enter one of the specified characters in the
MAIN menu selection box.
724
This selection requires a form
name to be supplied.
Specify a form name in the appropriate box, or
enter a different character in the selection
box.
725
Err writing form int’m. rec for
form !. File Full? (FSERR !!!)
See error 123. Field Symbol Table error.
726
Internal error initializing the
form!.
727
A forms file has not yet been
specified, so selection is
invalid.
To copy or compile from MAIN menu, forms
file must have been specified on FORMS FILE
menu.
728
File does not exist. Press ENTER
to create file.
734
There was an error trying to open
this forms file. (FSERR !!!!)
736
Internal error reading the forms
file. (FSERR !!!!)
740
There are no forms in this forms
file.
Specified forms file has no defined forms.
742
Save field length cannot be
blank.
Enter number of characters in save field on
SAVE FIELD menu.
743
Save field length must be an
integer greater than 0.
744
This save field already exists.
Use a new save field name.
745
A forms file can only have 20
save fields.
746
There are no save fields in this
forms file.
747
The save field name cannot be
blank.
Enter a save field name on the SAVE FIELD
menu.
748
WARNING: Forms file modified and
not compiled.Press EXIT to exit.
You modified the forms file and then pressed
EXIT. If you want to compile before
terminating FORMSPEC, press MAIN,
otherwise press EXIT again.
749
This file is a Fast Forms File
and cannot be modified.
You are attempting to modify a fast forms file;
use the forms file name you originally
specified.
750
This file is a Reformat file; use
REFSPEC to modify it.
Specify a forms file name, or RUN
REFSPEC.PUB.SYS to modify the reformat file.
Error Message Cause/Action