HP ARPA File Transfer Protocol User's Guide (36957-90159)

90 AppendixB
Error Messages
FTP User Messages and Errors
CAUSE: A connection request to a remote FTP server was accepted.
ACTION: None.
(FTPINFO 41) MESSAGE: Interactive mode on.
CAUSE: The PROMPT command was issued while prompting was disabled.
ACTION: None.
(FTPINFO 42) MESSAGE: Interactive mode off.
CAUSE: The PROMPT command was issued while prompting was enabled.
ACTION: None.
(FTPINFO 43) MESSAGE: Lower case on.
CAUSE: The CASE command was issued while “Forcing Lower Case” was disabled.
ACTION: None.
(FTPINFO 44) MESSAGE: Lower case off.
CAUSE: The CASE command was issued while “Forcing Lower Case” was enabled.
ACTION: None.
(FTPERR 45) MESSAGE: File accessed exclusively.
CAUSE: The file is already being accessed exclusively by the system or by another user.
ACTION: If the file is being accessed by the system, there is nothing you can do. If the file is
being accessed by another user, try again later.
(FTPERR 46) MESSAGE: File name too long.
CAUSE: The filename specified is longer than the maximum allowed by MPE:
“FILENAME/LOCKWORD.GROUPNAM.ACCTNAME”. As of release 4.5, MPE/iX
supports longer filenames, but unless the first character of that name is a dot (.) or a slash
(/), the name will be interpreted as an MPE name.
ACTION: Specify a file name that is shorter or starts with a dot or a slash.
(FTPERR 47) MESSAGE: Indirect file not found.
CAUSE: The indirect file name specified in the mput command was not found: “mput
^filename”.
ACTION: Make sure the indirect file exists.
(FTPERR 48) MESSAGE: Could not change directory to “!”.
CAUSE: The directory specified does not exist or is not accessible.
ACTION: Check to see if the directory exists and if so, what its access rights are.
(FTPINFO 49) MESSAGE: Connection time-out value set to ! seconds.
CAUSE: User entered "TIMEOUT [num-secs]"
ACTION: If num-secs was specified, the connection time-out value was set. Otherwise, the
current value was simply displayed.
Note: a value of 0 indicates no time-outs.