Customizing Terminal and Printer Type Files with the Workstation Configurator (32022-90031)

38 Chapter 3
Using a New Terminal or Printer Type File
Linking Terminal and Printer Type Files to Ldev Numbers
2. The system will display various shutdown messages. Wait until the
following message is displayed on the screen:
Shutdown of operation system complete
3. Enter these commands:
[CTRL]- B
CM> RS
4. Answer YES to the question: Restart the system?.
The system will reset and display the ISL prompt. Type the
following command to start the system:
ISL> START NORECOVERY
NOTE [CTRL]-A means press the [CTRL] key and the A key simultaneously.
Shutdown normally takes several minutes.
5. To reset the DTC, turn off the power and then turn on the power
again for the DTC. You should reboot the DTC after rebooting the
MPE/iX system.
You may also use TermDSM, an online diagnostic program for
host-managed DTCs, to reset the DTC. Refer to Troubleshooting
Terminal, Printer, and Serial Device Connections for more
information.