Customizing Terminal and Printer Type Files with the Workstation Configurator (32022-90031)

30 Chapter 2
Modifying a Terminal or Printer Type File
Step 6: Assigning Printer Control
1. Press the [Tab] key to move the cursor to the Wait time for
reply to status request (5..180 seconds) field. Enter a
time that is long enough for the status request reply to return during
peak periods of network traffic.
2. Type the number of seconds, from 5 to 180.
To configure the number of retries that are made when the wait timer:
1. Press the
[Tab] key to move the cursor to the Read retries for
XON and status request reply (0..100 retries) field.
When the wait time for a reply to status expires, the driver sends a
message to the console and retries the read for as many attempts as
are specified here.
2. Type the number of read retries, from 0 to 100.
To specify the number of seconds to wait before sending a disconnect
request to a remote printer port:
1. Press the
[Tab] key to move the cursor to the Wait time for
FOPEN before disconnect (0..90 seconds or 99,
99=infinite) field.
2. Type the number of seconds from 0 to 90, or type 99 if the HP 3000
should wait indefinitely.
To specify if duplex printing is supported:
1. Press the
[Tab] key to move the cursor to the Does the printer
support duplex printing field.
2. Specify yes or no for duplex printing.
After the data has been entered on this screen, press the
[Enter] key and
the Next Form
[F6] function key.