Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 5 77
Configuring Serial Devices (for Host-Based Management)
Modify the Network Management Configuration File
Step 3: Configure the Local Node Name
The Main screen is displayed after you press the [Open Config] key
(Figure 5-2). This screen lets you specify the HP 3000 host’s name. It
also asks whether you are using the HP 3000 host or an OpenView
Windows Workstation (PC) for DTC management, and if you are using
X.25 or PAD.
Figure 5-2 Main Screen
1. Assign a node name to the HP 3000 host in the “local HP 3000
node name” field. Use the format nodename.domain.organization.
If your HP 3000 host is the only computer in your network, you may
enter any node name. If you have several computers on your
network, you must make sure the node names for each host are
unique. Refer to Chapter 2, “Before Configuring Terminal and
Printer Connections,” for more information on node name.
2. In the field after the question, “Are you using the OpenView
DTC Manager?”, enter an N.
This means that you will not use the OpenView DTC Manager (that
is, use a PC to manage your DTCs). Instead, you will use the
HP 3000 host to manage your DTCs.
If you specify “Y” for using OpenView DTC Manager refer to
Chapter 6, “Configuring Serial Devices (for PC-Based
Management).”