Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

68 Chapter4

Dynamic Conﬁguration and DTS Shutdown/Restart

DTS Shutdown

Performing a DTS Shutdown

To perform a DTS shutdown, type the DTCCNTRL command at the CI

prompt either without specifying the desired shutdown operation or by

specifying it using the syntax outlined below:

• DTS shutdown operation not speciﬁed:

• DTS shutdown operation speciﬁed:

:DTCCNTRL func=shutdown

or to invoke the “forced” option:

:DTCCNTRL func=shutdown, forced=y

CAUTION

When the “forced” option is invoked, then all sessions logged on to TIO

devices will be aborted and all spooled TIO printers will be stopped.

NOTE

To dynamically conﬁgure DTS changes, refer to the “Dynamic

Conﬁguration” section earlier in this chapter. To automatically

add/conﬁgure a host-based managed DTC to DTS without needing to

specify detailed conﬁguration information such as DTC cards/boards

and ldevs, refer to Chapter 3, “Automatic Conﬁguration of DTCs.” To

manage/dynamically conﬁgure host-based X.25 links, refer to the

Conﬁguring and Managing Host-Based X.25 Links manual.

:DTCCNTRL

0 exit

1 dynamically implement DTS changes made in NMMGR

2 view status of last DTS dynamic configuration

3 automatically add a new DTC

4 shutdown DTS subsystem

5 restart DTS subsystem

6 manage/dynamically configure host-based x.25

7 help

For help on these topics, select 7 at the prompt below.

Select one of the numbers above corresponding to the

desired operation: 4