Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

66 Chapter4

Dynamic Conﬁguration and DTS Shutdown/Restart

Performing a Dynamic Conﬁguration

Dynamic Conﬁguration Status

You can also use DTCCNTRL to check the status of the last dynamic

conﬁguration. To see the status of the last dynamic conﬁguration, type

the DTCCNTRL command at the CI prompt either without specifying the

desired operation or by specifying it using the syntax outlined below:

• View status operation not speciﬁed:

• View status operation speciﬁed:

:DTCCNTRL func=dcstatus

If there were no errors from the last dynamic conﬁguration

performed by invoking DTCCNTRL, you will see the message “No

errors from last DTS dynamic configuration.” If errors

occurred during the last dynamic conﬁguration, you will see the

message “Errors occurred from the last DTS dynamic

configuration. See LOGDCC.PUB.SYS for error detail.”

Refer to the previous section in this chapter, “LOGDCC and

LOGDCCBK Files,” for more information on the LOGDCC ﬁle.

:DTCCNTRL

0 exit

1 dynamically implement DTS changes made in NMMGR

2 view status of last DTS dynamic configuration

3 automatically add a new DTC

4 shutdown DTS subsystem

5 restart DTS subsystem

6 manage/dynamically configure host-based x.25

7 help

For help on these topics, select 7 at the prompt below.

Select one of the numbers above corresponding to the

desired operation: 2