Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 4 63

Dynamic Conﬁguration and DTS Shutdown/Restart

Performing a Dynamic Conﬁguration

DTCCNTRL After NMMGR Exit

If you choose not to invoke DTCCNTRL implicitly within NMMGR, you

can run the command from the CI prompt at any time after you exit

NMMGR. DTCCNTRL requires that you have a minimum of Network

Manager (NM) capability.

The command can be entered either without specifying the desired

dynamic conﬁguration operation or by specifying it using the syntax

outlined below:

• Dynamic conﬁguration operation not speciﬁed:

• Dynamic conﬁguration operation speciﬁed:

:DTCCNTRL func=dynconf

Refer to Chapter 5, “Conﬁguring Serial Devices (for Host-Based

Management),” and Chapter 6, “Conﬁguring Serial Devices (for

PC-Based Management),” for more information on actions required for

changes to take effect.

NOTE

You must have made all desired DTS changes in NMMGR ﬁrst before

invoking DTCCNTRL from the CI prompt.

:DTCCNTRL

0 exit

1 dynamically implement DTS changes made in NMMGR

2 view status of last DTS dynamic configuration

3 automatically add a new DTC

4 shutdown DTS subsystem

5 restart DTS subsystem

6 manage/dynamically configure host-based x.25

7 help

For help on these topics, select 7 at the prompt below.

Select one of the numbers above corresponding to the

desired operation: 1