Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

58 Chapter4
Dynamic Configuration and DTS Shutdown/Restart
Dynamic Configuration
Host-based X.25 configuration changes: Use DTCCNTRL to:
– change PAD access 1) Stop X.25/PADSUP
– change level 1, 2, or 3 configuration 2) Start X.25/PADSUP
(see Configuring and Managing Host-Based
X.25 Links (36939-61004) for more
information)
Add/configure new DTC Reboot or reset DTC
or
Perform automatic configuration (see
character 3 for more information)
Add/configure a TIO card 1) Logoff any sessions that were logged on
through the changed DTC
Change DTC IP address 2) Reboot DTC (see Chapters 5/6, step 9, for
more information)
Change AFCP/management timers You may also use TermDSM to reset the DTC
(see Troubleshooting Terminal, Printer, and
Serial Device Connections (32022-61002) for
more information)
Change SNMP MIB data
Change SNMP trap destination
Change from host-based TIO to host-based X.25 1) Use DTCCNTRL to shutdown/restart DTS
(see Chapters 5/6, step 9, for more
information)
Change DTC LAN address 2) Reboot DTC
Change DTC name You may also use TermDSM to reset the DTC
(see Troubleshooting Terminal, Printer, and
Serial Device Connections(32022-61002) for
more information)
Change DTC node name
Change from PC-based to host-based or vice
versa
Change NLIO from Y to N in terminal profile
Change initially spooled in printer profile
Change HP 3000 characteristics:
– node name
– link name
– physical path of LANIC
Add X.25 card to DTC when none previously
existed
Task
Action Required for Change to Become
Active