Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

230 AppendixD
Error Messages
Validation Error Messages
Internal error. Failed to get memory. (DTSERR=77)
(DTSERR 77) Cause: The operating system was unable to allocate the memory
needed to store data used during validation.
Action: Build a new file from the sample file NMSAMP1.PUB.SYS. Try
to validate the file. If the same error message appears when verifying
the new file, contact your Hewlett-Packard support representative.
Path: NMMGRpath — Back-to-Back, currently configured on LDEV
#nnn, must use LDEV # -1. (DTSERR=78)
(DTSERR 78) Cause: A profile of type HOST has been configured on a DTC port and
the ldev specified is not -l.
Action: Ports using HOST profiles are for back-to-back and must have
an ldev of -l. Go to the screen specified in NMMGRpath and change the
ldev to -l or use a different profile that is not of type HOST.
Path: NMMGRpath — X.25 card is not allowed in slot s. (DTSERR=79)
(DTSERR 79) Cause: An X.25 card has been configured in a slot that is not allowed
for the DTC type.
Action: Go to the DTC specified in the NMMGRpath and delete the
X.25 card from the slot number s.
Path: NMMGRpath — Too many X.25 cards are configured. Maximum
is 3. (DTSERR=80)
(DTSERR 80) Cause: To many X.25 cards have been configured in the DTC specified
in NMMGRpath.
Action: Go to the DTC specified in the NMMGRpath and delete one or
more X.25 cards.
Path: NMMGRpath — LAN cardtype is not allowed on DTC16 or
DTC48. (DTSERR=81)
(DTSERR 81) Cause: The configuration for the DTC specified in NMMGRpath has a
cardtype of “L” configured. This is not allowed for DTC 16 or DTC 48.
Action: Go to the DTC Configuration screen specified in NMMGRpath
and enter the correct cardtypes.
Path: NMMGRpath — Too many LAN cards configured. Only one is
allowed. (DTSERR=82)
(DTSERR 82) Cause: The configuration for the DTC specified in NMMGRpath has
more than one LAN card specified in the cardtypes.
Action: Go to the DTC Configuration screen specified in NMMGRpath
and change the extra “L” cardtypes to another valid type.