Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 8 169
Additional DTC Configuration
Configuring SNMP
Configuring Trap Destinations
To specify the SNMP managers that will receive any SNMP error
messages generated by the DTC, access the SNMP Trap. Destination
Configuration screen. This screen can be accessed by pressing the
[Go To Trap] key at the SNMP MIB Configuration screen or SNMP
Authorization Filter Configuration screen.
The SNMP Trap Destination Configuration screen for host-based
management is shown in Figure 8-6. You can configure up to ten IP
addresses for trap destinations.
Figure 8-6 SNMP Trap Destination Screen
The “DTC Name” field is a read-only field which indicates the SNMP
configuration is for that specific DTC.
1. Enter the IP address of the SNMP manager in the “IP Address”
field.
The IP address must be a valid individual IP address; the global
definition of IP addresses, “*.*.*.*” or “@.@.@.@”, is not valid for
this screen.
Note: Only DTC MIBs can send error trap information. Make sure
that all IP addresses entered have MIB View = “1” (see SNMP
Authorization Filter Configuration screen).
2. After you have configured the trap destinations, press the
[Save Data]
function key.