Configuring Systems for Terminals, Printers, and Other Serial Devices (32022-90051)

Chapter 7 147
Terminal and Printer Profiles
Host Profile Screen (Host-Based)
Data
Length/Parity
Specifies the type of parity and data length will be used
using this profile. The full list of supported data length
with parity settings is as given:
None means that the 8 bits data length with parity
none will be used.
Even means that the 7 bits data length with even
parity will be used.
Odd means that 7 bits data length with odd parity will
be used.
0s means that 7 bits data length with parity forced to 0
will be used.
1s means that 7 bits data length with parity forced to 1
will be used.
8eve means that 8 bits data length with even parity
will be used. (Supported on DTC 16iX/DTC 16MX and
DTC 72MX only.)
8odd means that 8 bits data length with odd parity will
be used. (Supported on DTC 16iX/DTC 16MX and
DTC 72MX only.)
Data transfer
Specifies the mode of data transfer in back-to-back
connections. Field may be either ASCII or binary.
Default is ASCII.
Number of
stop bits Specifies the number of stop bits to be used for
asynchronous characters. The possible values are 1 or 2
stop bits. Default value is 1. Enter a 1 to set 1 stop bit.
Enter a 2 to set 2 stop bits. This is applicable only for
DTC 72MX, DTC 16MX and DTC 16iX. This field does
not apply for DTC 16RX access to an HP 3000 in an
MPE/iX host-based management environment, and any
value entered in this field for a DTC 16RX will be
ignored.
Enable
port? Specifies whether communication can pass through the
port. If disabled, no communication can pass through
the port. Default is Y.